2013

 Remove (page 992)

All (page 993)
Select faces (taper) Specifies the faces to be tapered and then sets the slope
of the taper.
 Base point. Sets the first point for determining the plane.
 Another point along the axis of tapering. Sets the orientation of
the axis that determines the direction of the taper.
 Taper angle. Specify an angle between -90 and +90 degrees to set the
slope of the taper from the axis.
Face: Delete
Delete Deletes or removes faces, including fillets and chamfers.
Use this option to remove and later modify filleted and chamfered edges. The
face is not deleted if the change results in a non-valid 3D solid.
 Select faces (copy) (page 1001)
 Undo. Cancels the selection of the faces that you selected most recently.

Remove (page 992)

All (page 993)
Select faces (delete) Specifies the face to be removed. The face must be in a
location that can be filled by surrounding faces after it is removed.
Face: Copy
Copy Copies faces as a region or a body. If you specify two points, SOLIDEDIT
uses the first point as a base point and places a single copy relative to the base
point. If you specify a single point (usually entered as a coordinate) and then
press Enter, SOLIDEDIT uses the coordinate as the new location.
1000 | Chapter 2 Commands