2013

If the path is a spline, the path should be perpendicular to the plane of
the profile and at one of the endpoints of the path. If not, the profile is
rotated to be perpendicular to the spline path. If one of the endpoints of
the spline is on the plane of the face, the face is rotated about the point;
otherwise, the spline path is moved to the center of the profile and the
profiles are rotated about its center.
If the path contains segments that are not tangent, the object is extruded
along each segment and then the joint along the plane is mitred, bisecting
the angle formed by the segments. If the path is closed, the profile lies on
the miter plane. This allows the start and end sections of the solid to match
up. If the profile is not on the miter plane, the path is rotated until it is
on the miter plane.
Face: Move
Move Moves the selected face on a 3D solid object to a specified height or
distance. You can select multiple faces at one time.
 Select faces (page 996)
 Undo. Cancels selection of the faces that you selected most recently.

Remove (page 992)

All (page 993)
You can change the shape of the object by moving its faces. This option is
recommended for minor adjustments.
S Commands | 995