2013

Table Of Contents

Summary

2D solids are filled only when the FILLMODE (page 1336) system variable is on

(1) and the viewing direction is orthogonal to the 2D solid.

List of Prompts

The following prompts are displayed.

First point Sets the first point in the 2D solid.

Second point Sets the first edge of the 2D solid.

Third point Sets the corner that is opposite the second point.

Fourth point or <exit> The fourth point is diagonally opposite the first point.

Pressing Enter at the Fourth Point prompt creates a filled triangle. Specifying

a fifth point creates a quadrilateral area.

Specifying successive third and fourth points creates further connected triangles

and four-sided polygons in a single solid object.