2013

Style
Specifies the format of the snap grid, which is Standard or Isometric. (SNAP-
STYL
(page 1483) system variable)
Standard
Sets a rectangular snap grid that is parallel to the XY plane of the current UCS.
X and Y spacing may differ.
Spacing Specifies the overall spacing of the snap grid.
Aspect Specifies the horizontal and vertical spacing of the snap grid separately.
Isometric
Sets an isometric snap grid, in which the snap locations are initially at
30-degree and 150-degree angles. Isometric snap cannot have different Aspect
values. The lined grid does not follow the isometric snap grid.
ISOPLANE (page 535) determines whether the crosshairs lie in the top isometric
plane (30- and 150-degree angles), the left isoplane (90- and 150-degree angles),
or the right isoplane (30- and 90-degree angles).
Type
Specifies the snap type, polar or rectangular. This setting is also controlled by
the
SNAPTYPE (page 1484) system variable.
Polar Sets the polar angle increment. (
POLARANG (page 1441) system variable)
Grid Sets the snap to Grid. When you specify points, the cursor snaps along
vertical or horizontal grid points.
See also:
Adjust Grid and Grid Snap
SOLDRAW
Generates profiles and sections in layout viewports created with SOLVIEW.
988 | Chapter 2 Commands