2013

NOTE You cannot select meshes created with the EDGESURF (page 403),
REVSURF (page 917), RULESURF (page 924), and TABSURF (page 1073) commands.

Point on desired side (page 986)

Keep both sides (page 986)
Z axis Defines the cutting plane by specifying a point on the plane and another
point on the Z axis (normal) of the plane.
 Specify a point on the section plane. Sets a point on the slicing plane.
 Specify a point on the Z-axis (normal) of the plane. Specifies a
point that defines the axis that is perpendicular to the slicing plane.
 Point on desired side (page 986)

Keep both sides (page 986)
View Aligns the cutting plane with the current viewport's viewing plane.
Specifying a point defines the location of the cutting plane.
 Specify a point on the current view plane. Sets a point on the object
to start the slice.

Point on desired side (page 986)

Keep both sides (page 986)
XY Aligns the cutting plane with the XY plane of the current user coordinate
system (UCS). Specifying a point defines the location of the cutting plane.
984 | Chapter 2 Commands