2013

Analysis Options Dialog Box
Sets the display options for zebra, curvature, and draft analysis.
List of Tabs
The Analysis Options dialog box contains the following tabs:
 Zebra (page 64)
 Curvature (page 65)
 Draft Angle (page 66)
See also:
Analyze Surfaces
Zebra Tab (Analysis Options Dialog Box)
Changes the display settings for the ANALYSISZEBRA command.
List of Options
The following options are displayed.
Select Objects to Analyze
Prompts you to select the surface objects to analyze. When you are done
selecting objects, press Enter to return to the dialog box.
Stripe Display
Stripe Direction
Specifies the display angle. (VSAZEBRADIRECTION (page 1544)) This option is
only available when Type is set to Cylinder. If you are using the Chrome Ball
type, change the stripe directions with the VSAZEBRADIRECTION (page 1544)
system variable.
Type
Sets analysis display type. (
VSAZEBRATYPE (page 1545))
Size
Sets the width of the zebra stripes. (VSAZEBRASIZE (page 1544))
Color 1
64 | Chapter 2 Commands