2012

DescriptionAttribute
 .dbx – ObjectDBX
 .lsp, .fas, or – AutoLISP
It your application will handle multiple languages, differ-
ent versions of a specific component to support different
languages can be specified by combining ModuleName
with a locale code. See Supported Locale Codes (page
100) for a full list of supported locale codes.
NOTE All path specifiers are '/' and not '\', and paths
are relative to the root .bundle folder.
AutoLISP only - When True, the AutoLISP file is loaded
once per document. Default is True.
PerDocument
Multiple values can be specified - Defines the load beha-
vior parameters for the component with LoadReasons
Loadreasons
and the exception of the LoadOnCommandInvocation
parameter.
By default, LoadOnAutoCADStartup, LoadOnAppearance
and LoadOnProxy are enabled (set to True) if LoadReas-
ons is not specified. If parameters need to be disabled
(set to False), the LoadReasons element must be specified
along with the parameters set to False.
By default, LoadOnCommandInvocation is disabled, en-
abling it will disable LoadOnAutoCADStartup and
LoadOnAppearance unless they are explicitly enabled.
See the ObjectARX Reference Guide for full details on
AcadAppInfo LoadReasons.
Valid parameter values:
 True – Parameter is enabled
 False – Parameter is disabled
The following parameters are available:
 LoadOnCommandInvocation. Load only when
a custom commands is invoked. When using this
parameter, a ‘Commands’ element must be included.
If LoadOnCommandInvocation is enabled, LoadO-
nAutoCADStartup and LoadOnAppearance are as-
98 | Chapter 7 Introduction to Programming Interfaces