2012

Height of extrusion Sets the direction and distance of the extrusion. Entering
a positive value extrudes the face in the direction of its normal. Entering a
negative value extrudes the face in the direction opposite to its normal.
 Angle of taper for extrusion. Specify an angle between -90 and +90
degrees.
Tapering the selected face with a positive angle tapers the face in, and a
negative angle tapers the face out. The default angle, 0, extrudes the face
perpendicular to its plane. All selected faces in the selection set are tapered
to the same value. If you specify a large taper angle or height, you can
cause the face to taper to a point before it reaches the extrusion height.
Path Sets a path for the extrusion path based on a specified line or curve. All
the profiles of the selected face are extruded along the chosen path to create
the extrusion.
 Select an extrusion path.
960 | Chapter 2 Commands