2012

direction. Silhouettes and edges are generated for all solids and portions of
solids behind the cutting plane. For sectional views, cross-hatching is created
using the current values of the
HPNAME (page 1326), HPSCALE (page 1329), and
HPANG (page 1319) system variables.
Any existing profiles and sections in the selected viewport are deleted, and
new ones are generated. All layers, except those required to display the profile
or section, are frozen in each viewport.
WARNING Do not place permanent drawing information on the view name-VIS,
view name-HID, and view name-HAT layers. The information stored on these layers
is deleted and updated when SOLDRAW is run.
To undo a viewport drawn by SOLDRAW, you must use the Back option of
UNDO (page 1089).
See also:
Create a Flattened View
SOLID
Creates solid-filled triangles and quadrilaterals.
Summary
For example:
2D solids are filled only when the FILLMODE (page 1298) system variable is on
(1) and the viewing direction is orthogonal to the 2D solid.
Commands | 955