2012

ISOPLANE (page 533) determines whether the crosshairs lie in the top isometric
plane (30- and 150-degree angles), the left isoplane (90- and 150-degree angles),
or the right isoplane (30- and 90-degree angles).
Type
Specifies the snap type, polar or rectangular. This setting is also controlled by
the SNAPTYPE (page 1441) system variable.
Polar
Sets the polar angle increment.
(
POLARANG (page 1400) system variable)
Grid Sets the snap to Grid. When you specify points, the cursor snaps along
vertical or horizontal grid points.
See also:
Adjust Grid and Grid Snap
SOLDRAW
Generates profiles and sections in layout viewports created with SOLVIEW.
Access Methods
Menu: Draw  3D Modeling  Setup  Drawing
Summary
After using SOLVIEW, visible and hidden lines representing the silhouette
and edges of solids in the viewport are created and then projected to a plane
perpendicular to the viewing direction.
List of Prompts
The following prompts are displayed.
Select viewports to draw ...
Select objects: Select the viewports to be drawn
SOLDRAW can only be used in viewports that have been created with SOLVIEW
(page 975).
Visible and hidden lines representing the silhouette and edges of solids in the
viewport are created and then projected to a plane perpendicular to the viewing
954 | Chapter 2 Commands