2012

 Select a circle, ellipse, arc, 2D-spline, or 2D-polyline. Specifies the
object to use for alignment.
Surface Aligns the cutting plane with a surface.
 Select a surface. Specifies a surface to be used for alignment.
NOTE You cannot select meshes created with the
EDGESURF (page 399),
REVSURF (page 905), RULESURF (page 912), and TABSURF (page 1039) commands.

Point on desired side (page 951)

Keep both sides (page 952)
Z axis Defines the cutting plane by specifying a point on the plane and another
point on the Z axis (normal) of the plane.
 Specify a point on the section plane. Sets a point on the slicing plane.
 Specify a point on the Z-axis (normal) of the plane. Specifies a
point that defines the axis that is perpendicular to the slicing plane.
Commands | 949