2012

With the POLYSOLID command, you can convert an existing line, 2D polyline,
arc, or circle to a solid with a rectangular profile. A polysolid can have curved
segments, but the profile is always rectangular by default.
You can draw a solid with POLYSOLID just as you would a polyline. The
PSOLWIDTH (page 1409) system variable sets the default width for the solid.
The
PSOLHEIGHT (page 1409) system variable sets the default height for the
solid.
List of Prompts
The following prompts are displayed.
Specify start point or [
Object (page ?)/Height (page
?)/
Width (page ?)/Justify (page ?)] <Object>: Specify a start
point for the profile of the solid, press Enter to specify an object to convert to a
solid, or enter an option
824 | Chapter 2 Commands