2012

depending on the direction in which a polyline was created, the text in the
linetype might be displayed upside down.
Undo
Reverses operations as far back as the beginning of the PEDIT session.
3D Polygon Mesh Selection (PEDIT)
If you select a polygon mesh, the following prompt is displayed:
List of Prompts
The following prompts are displayed.
Enter an option [Edit vertex/Smooth
surface/Desmooth/Mclose/Nclose/Undo]: Enter an option or press Enter
to end the command
Mclose and Nclose are replaced by Mopen and Nopen if the polygon mesh is
currently closed in the M or N direction.
Edit Vertex
Edits individual vertices of a polygon mesh that can be seen as a rectangular
M by N array, where M and N are the dimensions specified in
3DMESH (page
35). The
SURFTAB1 (page 1454) and SURFTAB2 (page 1454) system variables store
M and N values for
RULESURF (page 912), TABSURF (page 1039), REVSURF (page
905), and
EDGESURF (page 399).
Pressing Enter accepts the current default, which is either Next or Previous.
Next Moves the X marker to the next vertex. The marker does not wrap around
from the end to the start of the mesh, even if the mesh is closed.
Previous Moves the X marker to the previous vertex. The marker does not
wrap around from the start to the end of the mesh, even if the mesh is closed.
Commands | 779