2012

Close
Creates the closing segment of the polyline, connecting the last segment with
the first. The polyline is considered open unless you close it with Close.
Open
Removes the closing segment of the polyline. The polyline is considered closed
unless you open it with Open.
Join
Joins an open curve to the 3D polyline. The curve can be on a different plane,
but must be contiguous with the 3D polyline.
Edit Vertex
Performs various editing tasks on one vertex of the polyline and segments
that follow it.
Next
Moves the X marker to the next vertex. The marker does not wrap around
from the end to the start of the polyline, even if the polyline is closed.
Previous
Moves the X marker to the previous vertex. The marker does not wrap around
from the start to the end of the polyline, even if the polyline is closed.
Break
Saves the location of the marked vertex while you move the X marker to any
other vertex.

Next (page ?)
 Previous (page ?)
Go Deletes any segments and vertices between the two vertices you specify
and returns to Edit Vertex mode.
Exit Exits Break and returns to Edit Vertex mode.
If one of the specified vertices is at an end of the polyline, the polyline is
truncated. If both specified vertices are at endpoints of the polyline, or if just
one vertex is specified and it is at an endpoint, you cannot use Break mode.
Insert
Adds a new vertex to the polyline after the marked vertex.
Move
Moves the marked vertex.
Regen
Regenerates the polyline.
Commands | 777