2012

Tangent
Attaches a tangent direction to the marked vertex for use later in curve fitting.
Width
Changes the starting and ending widths for the segment that immediately
follows the marked vertex.
You must regenerate the polyline to display the new width.
Exit
Exits Edit Vertex mode.
Fit
Creates an arc-fit polyline, a smooth curve consisting of arcs joining each pair
of vertices. The curve passes through all vertices of the polyline and uses any
tangent direction you specify.
Spline
Uses the vertices of the selected polyline as the control points, or frame, of a
curve approximating a B-spline. This curve, called a spline-fit polyline, passes
through the first and last control points unless the original polyline was closed.
The curve is pulled toward the other points but does not necessarily pass
through them. The more control points you specify in a particular part of the
frame, the more pull they exert on the curve. Quadratic and cubic spline-fit
polylines can be generated.
Commands | 773