2012

List of Prompts
The following prompts are displayed.
Convert Lines, Arcs and Splines to polylines [Yes/No]? <Y>:
Enter yor n or press Enter
Specify a precision for spline conversion <10>: Enter a new
precision value or press Enter
The entered precision value affects all splines in the selection set. The precision
value is an integer between 0 and 99.
2D Polyline Selection (PEDIT)
If you select a 2D polyline, the following prompt is displayed:
List of Prompts
The following prompts are displayed.
Enter an option [Close/Join/Width/Edit
vertex/Fit/Spline/Decurve/Ltype gen/Reverse/Undo]: Enter an option
or press Enter to end the command
NOTE
You can select a single arc or line segment, also called a subobject, within a
polyline by pressing the Ctrl key when you click over it.
If the polyline you select is a closed polyline, Open replaces the Close option
in the prompt. You can edit a 2D polyline if its normal is parallel to and in
the same direction as the Z axis of the current UCS.
Close
Creates the closing segment of the polyline, connecting the last segment with
the first. The polyline is considered open unless you close it using the Close
option.
Commands | 769