2012

Table Of Contents

List of Prompts

The following prompts are displayed.

Select polyline or [

MULTIPLE (page 699)]: Use an object selection

method or enter m

The remaining prompts depend on whether you have selected a

2D polyline

(page 769), a 3D polyline (page 776), or 3D polygon mesh (page 779).

If the selected object is a line, arc, or a spline, the following prompt is

displayed:

Object selected is not a polyline.

Do you want it to turn into one? <Y>: Enter y or n, or press Enter

If you enter y, the object is converted into a single-segment 2D polyline that

you can edit. You can use this operation to join lines and arcs into a polyline.

Before the selected spline is converted to a polyline, the following prompt is

displayed:

Specify a precision <10>: Enter a new precision value or press Enter

The precision value determines how accurately the resulting polyline is to fit

to the source spline. Valid value is an integer between 0 and 99.

NOTE A high precision value may cause performance problems.

The

PLINECONVERTMODE (page 1395) system variable determines whether

the polylines are created with linear or arc segments. When the

PEDITACCEPT

(page 1389)system variable is set to 1, this prompt is suppressed, and the selected

object is automatically converted to a polyline.

The conversion in both PEDIT and SPLINEDIT will obey the DELOBJ (page

1213) system variable.