2012

Panning in Real Time
As a view is being panned, the cursor updates to let you know when you have
reached the extents of the drawing.
Summary
The cursor changes to a hand cursor. By holding down the pick button on
the pointing device, you lock the cursor to its current location relative to the
viewport coordinate system. The drawing display is moved in the same
direction as the cursor.
When you reach a logical extent (edge of the drawing space), a bar is displayed
on the hand cursor on that edge. Depending on whether the logical extent is
at the top, bottom, or side of the drawing, the bar is either horizontal (top or
bottom) or vertical (left or right side).
When you release the pick button, panning stops. You can release the pick
button, move the cursor to another location in the drawing, and then press
the pick button again to pan the display from that location.
To stop panning at any time, press Enter or Esc.
See also:
Pan or Zoom a View
-PAN
Moves the view planar to the screen by specifying a distance and direction
the view should be moved in.
List of Prompts
The following prompts are displayed.
Specify base point or displacement: Specify a point
764 | Chapter 2 Commands