2012

If you enter -osnap at the Command prompt, the following prompts are
displayed.
List of Prompts
The following prompts are displayed.
Current osnap modes: current
Enter list of object snap modes (page ?): Enter names of object
snap modes separated with commas, or enternoneoroff
Object Snap Modes
Specify one or more object snap modes by entering the first three characters
of the name. If you enter more than one name, separate the names with
commas.
TANgentCENterENDpoint
NEArestNODeMIDpoint
PARallelQUAdrantINTersection
INSertionEXTension
PERpendicularAPParent Intersection
For a description of each of these object snap modes, see the Object Snaps tab
of the Drafting Settings dialog box (page 364).
QUIck Snaps to the first snap point found. Quick must be used in conjunction
with other object snap modes.
NONe Turns off object snap modes.
See also:
Use Object Snaps
OVERKILL
Removes duplicate or overlapping lines, arcs, and polylines. Also, combines
partially overlapping or contiguous ones.
744 | Chapter 2 Commands