2012

List of Prompts
The following prompts are displayed.
Specify start point of polyline: Specify a point (1)
Specify
endpoint of line (page 47) or [Undo (page 47)]: Specify
a point or enter an option
Specify endpoint of line or [Undo]: Specify a point or enter an option
Specify endpoint of line or [
Close (page 47)/Undo]: Specify a
point or enter an option
Endpoint of Line Draws a straight line from the previous point to the specified
new point. The prompt is repeated until you press Enter to end the command.
Undo Deletes the last line created. You can continue drawing from the previous
point.
Close Draws a closing line from the endpoint back to the first point, and then
ends the command. To be closed, a 3D polyline must contain at least two
lines.
See also:
Draw Polylines
Commands | 47