2012

Specify point on side to offset Specify a point location to determine whether
the offset distance is applied inside or outside the edges of the face.
Corner
Specifies the type of corners on the offset object when it is created outside the
edges of the selected face.
Sharp Creates sharp corners between offset linear segments.
Rounded Creates rounded corners between offset linear segments, using a
radius that is equal to the offset distance.
See also:
Offset an Object
Add Facets to Faces on Solids and Surfaces
OOPS
Restores erased objects.
Summary
OOPS restores objects erased by the last ERASE (page 406) command.
You can also use OOPS after BLOCK (page 143) or WBLOCK (page 1125) because
these commands can erase the selected objects after creating a block.
You cannot use OOPS to restore objects on a layer that has been removed with
the
PURGE (page 849) command.
See also:
Erase Objects
Commands | 719