2012

You can specify a global scale as the ratio between the scale of the title block
in the layout and the drawing on the Model layout.
To easily specify all layout page settings and prepare your drawing for plotting,
you can also use the Page Setup Manager.
List of Prompts
When the
TILEMODE (page 1464) system variable is off, or when you enter y
or press Enter at the Enable Paper Space prompt, the following prompts are
displayed:
Enter an option [
Align (page ?)/Create (page ?)/Scale
viewports
(page ?)/Options (page ?)/Title block (page
?)/
Undo (page ?)]: Enter an option or press Enter to end the command
Align
Pans the view in a viewport so that it aligns with a base point in another
viewport. The current viewport is the viewport that the other point moves to.
Angled Pans the view in a viewport in a specified direction.
The next two prompts specify the distance and angle from the base point to
the second point.
Horizontal Pans the view in one viewport until it aligns horizontally with a
base point in another viewport. This option should be used only if the two
viewports are oriented horizontally. Otherwise, the view might be panned
outside the limits of the viewport.
Vertical Alignment Pans the view in one viewport until it aligns vertically
with a base point in another viewport. This option should be used only if the
two viewports are oriented vertically. Otherwise, the view might be panned
outside the limits of the viewport.
Rotate View Rotates the view in a viewport about a base point.
Undo Reverses operations performed in the current MVSETUP session.
Create
Creates viewports.
Delete Objects
Deletes existing viewports.
Create Viewports
Displays options for creating viewports.
Layout Number to Load Controls creation of viewports.
Entering 0 or pressing Enter creates no viewports.
Commands | 705