2012

See also:
Create and Modify Layout Viewports
MVSETUP on the Model Layout
The Model layout is most useful for plotting multiple views of a drawing
within a single border.
On the Model layout, you set the units type, drawing scale factor, and paper
size at the Command prompt using MVSETUP. Using the settings you provide,
a rectangular border is drawn at the grid limits.
List of Prompts
When the
TILEMODE (page 1464) system variable is on (the default), the
following prompt are displayed:
Enable paper space? [No/Yes] <Y>: Enternor press Enter
Pressing Enter turns off TILEMODE and proceeds as described in the following
section, Using MVSETUP on a Layout Tab. (page 704)
Entering n displays the following prompt:
Enter units type
[Scientific/Decimal/Engineering/Architectural/Metric]: Enter
an option
A list of available units and prompts for the scale factor and paper size are
displayed.
Enter the scale factor: Enter a value
Enter the paper width: Enter a value
Enter the paper height: Enter a value
A bounding box is drawn and the command ends.
See also:
Create and Modify Layout Viewports
MVSETUP on a Named Layout
On a named layout, you can insert one of several predefined title blocks into
the drawing and create a set of layout viewports within the title block.
704 | Chapter 2 Commands