2012

 2Point (height) (page 620)

Axis endpoint (page 621)

Top radius (page 621)
If the specified criteria can produce multiple results, the closest tangent
points are used.
Elliptical Specifies an elliptical base for the mesh cone.
 Endpoint of first axis. Sets the start point for the first axis of the mesh
cone base and then specifies the other axis endpoints:
 Other endpoint of first axis. Sets the first axis endpoint.
 Endpoint of second axis. Sets the second axis endpoint
 Center. Specifies the method for creating an elliptical mesh cone base
that starts with the center point of the base:
 Center point. Sets the center of the mesh cone base.
 Distance to first axis. Sets the radius of the first axis.
 Endpoint of second axis. Sets the endpoint of the second axis.
Base radius Sets the radius of the mesh cone base.
 Height (page 620)

2Point (height) (page 620)

Axis endpoint (page 621)

Top radius (page 621)
Diameter Sets the diameter for the base of the cone.

Height (page 620)

2Point (height) (page 620)

Axis endpoint (page 621)

Top radius (page 621)
Height Sets the height of the mesh cone along an axis that is perpendicular
to the plane of the base.
2Point (height) Defines the height of the mesh cone by specifying the distance
between two points:
 First point. Sets the first point of a two-point distance.
620 | Chapter 2 Commands