2012

Smooth Fit
Specifies that a smooth solid or surface is drawn between the cross sections
and has sharp edges at the start and end cross sections. (
LOFTNORMALS (page
1358) system variable)
Start Continuity
Sets the tangency and curvature of the first cross section.
Start Bulge Magnitude
Sets the size of the curve of the first cross section.
End Continuity
Sets the tangency and curvature of the last cross section.
End Bulge Magnitude
Sets the size of the curve of the last cross section.
Normal To
Controls the surface normal of the solid or surface where it passes through
the cross sections. (
LOFTNORMALS (page 1358) system variable)
Start Cross Section Specifies that the surface normal is normal to the start
cross section.
Commands | 589