2012

Cross Sections Only
Creates lofted objects without using guides or paths.
Settings
Displays the
Loft Settings dialog box (page 588).
See also:
Create a Solid or Surface by Lofting
Loft Settings Dialog Box
Controls the contour of a lofted surface at its cross sections. Also allows you
to close the surface or solid.
List of Options
The following options are displayed.
Ruled
Specifies that the solid or surface is ruled (straight) between the cross sections
and has sharp edges at the cross sections. (
LOFTNORMALS (page 1358) system
variable)
588 | Chapter 2 Commands