2012

Cross Sections in Lofting Order Specifies open or closed curves in the order
in which the surface or solid will pass through them.
Point If you select the Point option, you must also select a closed curve.
Join Multiple Curves Joins multiple, end-to-end curves as one cross section.
Mode Controls whether the lofted object is a solid or a surface.
Options

Guides (page ?)

Path (page ?)

Cross sections only (page ?)

Settings (page ?)
Continuity This option only displays if the
LOFTNORMALS (page 1358) system
variable is set to 1 (smooth fit). Specifies whether the continuity is G0, G1, or
G2 where the surfaces meet.
Bulge Magnitude This option only displays if the LOFTNORMALS (page 1358)
system variable is set to 1 (smooth fit). Specifies a bulge magnitude value for
objects that have a continuity of G1 or G2.
Guides
Specifies guide curves that control the shape of the lofted solid or surface. You
can use guide curves to control how points are matched up on corresponding
586 | Chapter 2 Commands