2012

The file name without the extension is assigned as the image name. Image
names can include up to 255 characters and contain letters, digits, spaces, and
any special characters not used by the operating system or this program. If
the file name is not a valid name for a nongraphical object, the Substitute
Image Name dialog box is displayed. A valid image name is generated from
the file name and an underscore and number are appended to the name.
If a definition with the same name and path exists in the drawing, the
following prompts are displayed and the image is inserted as a copy:
Image file name has already been loaded.
Use IMAGE Reload to update its definition.
Specify insertion point <0,0>: Specify an insertion point
Base image size: Width: current width, Height: current height, current unit
Specify scale factor: Enter a value or press Enter
Specify rotation angle <0>: Enter a value or press Enter
If the
FILEDIA (page 1296) system variable is set to 0, the following prompt is
displayed instead of the dialog box:
Enter image file name to attach <last>: Enter an image name
The last image name attached to the drawing during the current session is the
default. To avoid errors when entering an image name, it is recommended
that you specify both the image name and the file name as follows:
imagename=path name/long file name.bmp
or
imagename="path name/long file name.bmp"
If you enter a valid image name without a file extension, the program searches
for the file in this order: first, an existing image definition in the drawing,
and second, an image file in the folders in order of the search path. The
program searches for all the image files with the specified name, regardless of
extension, and uses the first name found. If no image name or image file is
found, the message “Image Not Found” is displayed and the prompt is repeated.
To specify a long file name that does not conform to this program's naming
rules, enter the name as follows:
"imagename=filename"
You can use a dialog box to search for image files but still enter the
imagename=filename convention at the Command prompt. Enter a tilde (~) at
Commands | 511