2012

Add Boundaries
Modifies the boundaries of a hatch or fill by adding boundaries.
For more information, see
Add: Pick Points (page ?) or Add: Select Objects
(page ?).
Remove Boundaries
Modifies the boundaries of a hatch or fill by removing boundaries.
For more information, see Remove Boundaries (page ?).
Recreate Boundary
Creates a polyline or region around the selected hatch or fill, and optionally
associates the hatch object with it.
For more information, see
Recreate Boundary (page ?).
Associate
Specifies that the hatch or fill is associative. A hatch or fill that is associative
is updated when you modify its boundary objects.
Specify Internal Point Determines a boundary from existing objects that
form an enclosed area around the specified point, and associates the selected
hatch with the boundary objects.
Select Objects Determines a boundary from selected objects that form an
enclosed area, and associates the selected hatch with the boundary objects.
Separate Hatches
Controls whether a single hatch object or multiple hatch objects are created
when several separate closed boundaries are specified.
Origin
Controls the starting location of hatch pattern generation. Some hatches,
such as brick patterns, are meant to be aligned with a point on the hatch
boundary. By default, all hatch origins correspond to the current UCS origin.
Use Current Origin Sets the value of the
HPORIGINMODE (page 1328) system
variable. The last 5 options listed below correspond to the values 1-5.
Set New Origin Specifies the new hatch origin point directly.
Default to Boundary Extents Calculates a new origin based on the rectangular
extents of the hatch. Choices include each of the four corners of the extents
and its center. You can also store the value of the new hatch origin in the
HPORIGIN (page 1327) system variable.
Annotative
Specifies that the hatch is annotative. This property automates the process of
scaling annotations so that they plot or display at the correct size on the paper.
Commands | 499