2012

Edge Chain Selects a tangential sequence of edges when you select a single
edge. For example, if you select an edge on the top of a 3D solid box, FILLET
also selects the other tangential edges on the top.
Edge Switches to a single-edge selection mode.
Loop
Specifies a loop of edges on the face of a solid. For any edge, there are two
possible loops. After selecting a loop edge, you are prompted to Accept the
current selection, or choose the Next loop.
Radius
Defines the radius of the rounded edge.
Undo
Reverses the previous action in the command.
Polyline
Inserts fillet arcs at each vertex of a 2D polyline where two line segments meet.
Select 2D polyline:
If one arc segment separates two line segments that converge as they approach
the arc segment, FILLET removes the arc segment and replaces it with a fillet
arc.
Radius
Defines the radius of the fillet arc.
The value you enter becomes the current radius for subsequent FILLET
commands. Changing this value does not affect existing fillet arcs.
Trim
Controls whether FILLET trims the selected edges to the fillet arc endpoints.
Commands | 435