2012

List of Prompts
The following prompts are displayed.
Specify inside diameter of donut <current>: Specify a distance or press
Enter
If you specify an inside diameter of 0, the donut is a filled circle.
Specify outside diameter of donut <current>: Specify a distance or
press Enter
Specify center of donut or <exit>: Specify a point (1) or press Enter
to end the command
The location of the donut is set based on the center point. After you specify
the diameters, you are prompted for the locations at which to draw donuts.
A donut is drawn at each point specified (2). How the interior of a donut is
filled depends on the current setting of the
FILL (page 431) command.
See also:
Draw Donuts
DRAGMODE
Controls the way dragged objects are displayed.
Commands | 359