2012

Dimension Line Location
Uses the point you specify to locate the dimension line and determines the
direction to draw the extension lines. After you specify the location, the
dimension is drawn.
Mtext
Displays the In-Place Text Editor, which you can use to edit the dimension
text. Use control codes and Unicode character strings to enter special characters
or symbols. See
Control Codes and Special Characters (page 1049).
If alternate units are not turned on in the dimension style, you can display
them by entering square brackets ([ ]). For more information about formatting
dimension text, see Select and Modify Objects.
The current dimension style determines the appearance of the generated
measurements.
Text
Customizes the dimension text at the Command prompt. The generated
dimension measurement is displayed within angle brackets.
To include the generated measurement, use angle brackets (< >) to represent
the generated measurement. If alternate units are not turned on in the
dimension style, you can display alternate units by entering square brackets
([ ]).
Dimension text properties are set on the Text tab of the New, Modify, and
Override Dimension Style dialog boxes.
Angle
Changes the angle of the dimension text.
Commands | 301