2012

Vertical (DCVERTICAL (page 263))
Constrains the Y distance between points on an object, or between two points
on different objects.
Aligned (
DCALIGNED (page 251))
Constrains the distance between two points on different objects.
Angular (DCANGULAR (page 253))
Constrains the angle between line or polyline segments, the angle swept out
by an arc or a polyline arc segment, or the angle between three points on
objects.
Radius (DCRADIUS (page 262))
Constrains the radius of a circle or an arc.
Diameter (DCDIAMETER (page 256))
Constrains the diameter of a circle or an arc.
Form (DCFORM (page 258))
Specifies whether the dimensional constraint being created is dynamic or
annotational.
Convert (
DCCONVERT (page 256))
Converts associative dimensions to dimensional constraints.
See also:
Apply Dimensional Constraints
DIMCONTINUE
Creates a dimension that starts from an extension line of a previously created
dimension.
Access Methods
Button
Toolbar: Annotation tool set  Dimensions tool group  Continue
flyout  Continue
Menu: Dimension  Continue
286 | Chapter 2 Commands