2012

NOTE
Dimension breaks can be added to dimensions for objects that do not intersect
the dimension or extension lines using the by Manual option.
Multiple Specifies multiple dimensions to add breaks to or remove breaks
from.
Auto Places dimension breaks automatically at all the intersection points of
the objects that intersect the selected dimension. Any dimension break created
using this option is updated automatically when the dimension or an
intersecting object is modified.
When a new object is drawn over the top of a dimension that has any
dimension breaks, no new dimension breaks are automatically applied at the
intersecting points along the dimension object. To add the new dimension
breaks, must be run the command again.
Remove Removes all dimension breaks from the selected dimensions.
Manual Places a dimension break manually. You specify two points on the
dimension or extension lines for the location of the break. Any dimension
break that is created using this option is not updated if the dimension or
intersecting objects are modified. You can only place a single manual
dimension break at a time with this option.
See also:
Break a Dimension Line
DIMCENTER
Creates the center mark or the centerlines of circles and arcs.
Access Methods
Button
Toolbar: Annotation tool set  Dimensions tool group  Center Mark
Menu: Dimension  Center Mark
Commands | 283