2012

Arc Length Dimension Location Specifies the placement of the dimension
line and determines the direction of the extension lines.
Mtext Displays the In-Place Text Editor, which you can use to edit the
dimension text. Use control codes and Unicode character strings to enter
special characters or symbols. See Control Codes and Special Characters (page
1049).
If alternate units are not turned on in the dimension style, you can display
them by entering square brackets ([]). For more information, see Select and
Modify Objects.
The current dimension style determines the appearance of the generated
measurements.
Text Customizes the dimension text at the Command prompt. The generated
dimension measurement is displayed within angle brackets.
To include the generated measurement, use angle brackets (< >) to represent
the generated measurement. If alternate units are not turned on in the
dimension style, you can display alternate units by entering square brackets
([ ]).
Dimension text properties are set on the Text tab of the New, Modify, and
Override Dimension Style dialog boxes.
Angle Changes the angle of the dimension text.
Partial Reduces the length of the arc length dimension.
Leader Adds a leader object. This option is displayed only if the arc (or arc
segment) is greater than 90 degrees. The leader is drawn radially, pointing
towards the center of the arc being dimensioned.
No Leader Cancels the Leader option before the leader is created.
To remove a leader, delete the arc length dimension and recreate it without
the leader option.
Commands | 279