2012

Access Methods
Button
Toolbar: Drafting tool set  Parametric tool group  Dimensional
Contraints flyout  Linear
Summary
This command is equivalent to the Linear option in
DIMCONSTRAINT (page
284).
The following table outlines the valid contraint objects and points:
CharacteristicsValid Objects or Points
Line
 When a line or an arc is selected, the
horizontal or vertical distance between
Polyline segment
the endpoints of the object is con-
strained.
Arc
Two constraint points on objects
When a line or an arc is selected, the horizontal or vertical distance between
the endpoints of the object is constrained.
List of Prompts
The following prompts are displayed.
Specify first
constraint point (page ?) or [Object (page
?)] <Object>: Pick a constraint point or select an object
Constraint Point
Specifies a constraint point for the object.
First Constraint Point Specifies the first point of the object to be constrained.
Second Constraint Point Specifies the second point of the object to be
constrained.
Dimension Line Location Determines where the dimension line is located
on the constrained object.
Object
Selects an object instead of a constraint point.
Commands | 261