2012

CharacteristicsValid Objects or Points
Two constraint points on objects
For example,
List of Prompts
The following prompts are displayed.
Specify first
constraint point (page ?) or [Object (page
?)] <Object>: Pick a constraint point or select an object
Constraint Point
Specifies a constraint point for the object.
First Constraint Point Specifies the first point of the object to be constrained.
Second Constraint Point Specifies the second point of the object to be
constrained.
Dimension Line Location Determines where the dimension line is located
on the constrained object.
Object
Selects an object instead of a constraint point.
See also:
Apply Dimensional Constraints
DCLINEAR
Creates a horizontal, vertical, or rotated constraint based on the locations of
the extension line origins and the dimension line.
260 | Chapter 2 Commands