2012

 Top Radius (page 209)
2P (Two Points)
Defines the base diameter of the cone by specifying two points.

2Point (page 209)
 Axis Endpoint (page 209)
 Top Radius (page 209)
TTR (Tangent, Tangent, Radius)
Defines the base of the cone with a specified radius tangent to two objects.
Sometimes, more than one base matches the specified criteria. The program
draws the base of the specified radius whose tangent points are closest to the
selected points.

2Point (page 209)
 Axis Endpoint (page 209)
 Top Radius (page 209)
Elliptical
Specifies an elliptical base for the cone.
Center Creates the base of the cone by using a specified center point.

2Point (page 209)

Axis Endpoint (page 209)
 Top Radius (page 209)
See also:
Create a Solid Cone
CONSTRAINTBAR
Displays or hides the geometric constraints on an object.
Access Methods
Button
210 | Chapter 2 Commands