2012

List of Prompts
The following prompts are displayed.
Specify first corner or [
Center (page ?)]: Specify a point or enter
c for center
Specify other corner or [
Cube (page ?)/Length (page ?)]:
Specify the other corner of the box or enteran option
If the other corner of the box is specified with a Z value that differs from the
first corner, then no height prompt is displayed.
Specify height or [2Point (page ?)] <default>: Specify the height
or enter 2P for the 2 Point option
Entering a positive value draws the height along the positive Z axis of the
current UCS. Entering a negative value draws the height along the negative
Z axis.
The base of the box is always drawn parallel to the XY plane of the current
UCS (work plane). The height of the box is specified in the Z-axis direction.
You can enter both positive and negative values for the height.
Center
Creates the box by using a specified center point.
Cube Creates a box with sides of equal length.
Commands | 153