2012

Temporarily closes the dialog box so that you can specify an insertion base
point in the current drawing.
X
Specifies the X coordinate value.
Y
Specifies the Y coordinate value.
Z
Specifies the Z coordinate value.
Block Behavior
Specifies the behavior of the block.
Scale Uniformly
Specifies whether or not the block reference is prevented from being
non-uniformly scaled.
Annotative
Specifies that the block is annotative.
Match Block Orientation to Layout
Specifies that the orientation of the block references in paper space viewports
matches the orientation of the layout. This option is unavailable if the
Annotative option is cleared.
Allow Exploding
Specifies whether or not the block reference can be exploded.
Units
Specifies units for the block.
Block Unit
Specifies the insertion units for the block reference.
Description
Specifies the text description of the block.
Open in Block Editor
Opens the current block definition in the
Block Editor (page 139) when the
dialog box is closed.
146 | Chapter 2 Commands