2012

List Controls whether a list of valid commands and system variables is
displayed as you type.
Icon Controls whether the corresponding icon for a command is displayed
in the list. The same icon is used for all system variables.
System variables Controls whether system variables are also included with
the Append and List features.
Delay Sets a time delay in seconds before the Append and List features take
effect.
On Enables the operation of the AutoComplete features that are currently
turned on.
Off Suppresses the operation of the AutoComplete features without changing
their settings.
See also:
The Command Line
Enter Commands on the Command Line
AUTOCONSTRAIN
Applies geometric constraints to a selection set of objects based on orientation
of the objects relative to one another.
Access Methods
Button
Toolbar: Drafting tool set  Parametric tool group  Auto
Menu: Parametric  AutoConstrain
Summary
You can apply geometric constraints to a selection set of geometry within the
specified tolerance set using the AutoConstrain tab in the
Constraint Settings
dialog box
(page 212).
Specify the Settings option to change the types of constraints applied, the
order in which they are applied, and the applicable tolerances.
126 | Chapter 2 Commands