2012

DrawingSaved in:
0Initial value:
Gaussian curvature (evaluates areas of high and low curvature)0
Mean curvature (evaluates the mean curvature of the U and V sur-
face curvature values)
1
Maximum curvature (evaluates the maximum curvature of the U
and V surface curvature values)
2
Minimum curvature (evaluates the minimum curvature of the U
and V surface curvature values)
3
See also:
ANALYSISOPTIONS (page 64)
ANALYSISOPTIONS - Curvature Tab (page 65)
VSADRAFTANGLEHIGH
Sets the value at which a model displays as green during draft analysis (
ANA-
LYSISDRAFT
(page 63)).
RealType:
DrawingSaved in:
3Initial value:
Draft angle is the angle in degrees between the surface normal and the UCS
plane. High value is set by this system variable.
Surface is parallel to the UCS with surface normal facing the
opposite direction as the construction plane
-90
Surface is perpendicular to the construction plane0
Surface is parallel to the construction plane with surface normal
facing the same direction as the UCS
90
System Variables | 1493