2012

See also:
Change to a View of the XY Plane
VIEWMODE
Stores the View mode for the current viewport.
(Read-only)
IntegerType:
DrawingSaved in:
0Initial value:
The setting is stored as a bitcode using the sum of the following values:
Turned off.0
Perspective view active.1
Front clipping on2
Back clipping on.4
UCS Follow mode on.8
Front clip not at eye. If on, the front clip distance ( FRONTZ (page
1300)) determines the front clipping plane. If off, FRONTZ is ignored,
16
and the front clipping plane is set to pass through the camera point
(vectors behind the camera are not displayed). This flag is ignored
if the front-clipping bit (2) is off.
See also:
Save and Restore Views
VIEWSIZE
Stores the height of the view displayed in the current viewport, measured in
drawing units.
System Variables | 1487