2012

UCSDETECT
Controls whether dynamic UCS acquisition is active or not.
IntegerType:
RegistrySaved in:
1Initial value:
Not active0
Active1
See also:
Use the Dynamic UCS with Solid Models
UCSFOLLOW
Generates a plan view whenever you change from one UCS to another.
IntegerType:
DrawingSaved in:
0Initial value:
The UCSFOLLOW setting is saved separately for each viewport. If UCSFOLLOW
is on for a particular viewport, a plan view is generated in that viewport
whenever you change coordinate systems.
Once the new UCS has been established, you can use
DVIEW (page 385), PLAN
(page 782), VIEW (page 1104), or VPOINT (page 1114) to change the view of the
drawing. It will change to a plan view again the next time you change
coordinate systems.
UCS does not affect the view0
Any UCS change causes a change to the plan view of the new UCS
in the current viewport
1
The setting of UCSFOLLOW is maintained separately for paper space and
model space and can be accessed in either, but the setting is ignored while in
paper space (it is always treated as if set to 0). Although you can define a
1478 | Chapter 4 System Variables