2012

SNAPUNIT
Sets the snap spacing for the current viewport.
2D-pointType:
DrawingSaved in:
0.5000,0.5000 (imperial) or 10.0000,10.0000 (metric)Initial value:
If SNAPSTYL is set to 1, the X value of SNAPUNIT is adjusted automatically
to accommodate the isometric snap.
Changes to this system variable are not reflected in the grid until the display
is refreshed.
See also:
Adjust Grid and Grid Snap
SOLIDCHECK
Turns 3D solid validation on and off for the current session.
IntegerType:
Not-savedSaved in:
1Initial value:
Off0
On1
See also:
Clean and Check 3D Solids
SOLIDHIST
Controls whether new composite solids retain a history of their original
components.
IntegerType:
DrawingSaved in:
1Initial value:
1442 | Chapter 4 System Variables