2012

Polylines in AutoCAD Release 14 or older drawings are converted
when opened; PLINE creates optimized polylines
2
For more information on the two formats, see the
CONVERT (page 220)
command.
PLINETYPE also controls the polyline type created with the following
commands:
BOUNDARY (page 149) (when object type is set to Polyline),
DONUT (page 358), PEDIT (page 767) (when selecting a line or arc), POLYGON
(page 821), and SKETCH (page 945) (when SKPOLY (page 1436) is set to 1).
See also:
Draw Polylines
PLINEWID
Stores the default polyline width.
RealType:
DrawingSaved in:
0.0000Initial value:
See also:
Draw Polylines
PLOTOFFSET
Controls whether the plot offset is relative to the printable area or to the edge
of the paper.
IntegerType:
RegistrySaved in:
0Initial value:
Sets the plot offset relative to the printable area.0
Sets the plot offset relative to the edge of the paper1
System Variables | 1397