2012

Table Of Contents

Perspective view turned on1

Perspective views are available only in model space, and only with 3D visual

styles.

NOTE

PERSPECTIVE is set to 0 when the drawing file or DXF file is saved to a file

format earlier than AutoCAD 2007.

See also:

Define a Perspective Projection (DVIEW)

PERSPECTIVECLIP

Determines the location of eyepoint clipping.

RealType:

RegistrySaved in:

5.0000Initial value:

The value determines where the eye point clipping occurs as a percentage.

Values can range between 0.01 and 10.0. If you select a small value, the z-values

of objects will be compressed at the target view and beyond. If you select a

value such as 0.5%, the clipping will appear very close to the eyepoint of the

view. In some extreme cases it might be appropriate to use 0.1%, but it is

recommended to change the setting to a higher value such as 5%.