2012

Multiple Lines
Specifies that the attribute value can contain multiple lines of text. When this
option is selected, you can specify a boundary width for the attribute.
NOTE In a dynamic block, an attribute's position must be locked for it to be
included in an action's selection set.
Insertion Point
Specifies the location for the attribute. Enter coordinate values or select Specify
On-screen and use the pointing device to specify the placement of the attribute
in relation to the objects that it will be associated with.
Specify On-Screen
Displays a Start Point prompt when the dialog box closes. Use the pointing
device to specify the placement of the attribute in relation to the objects that
it will be associated with.
Input Coordinates
Specifies the coordinates to use for the attribute’s insertion point.
X
Specifies the X coordinate of the attribute's insertion point.
Y
Specifies the Y coordinate of the attribute's insertion point.
Z
Specifies the Z coordinate of the attribute's insertion point.
See also:
Define Block Attributes
-ATTDEF
List of Prompts
The following prompts are displayed.
Current
attribute modes (page ?): Invisible=current
Constant=current Verify=current Preset=current Lock position=current
Annotative =current Multiple line =current
Commands | 111