2012

Table Of Contents

If LAYOUTREGENCTL is set to 1 or 2 and performance seems slow in general

or when you switch between layouts for which the display list is saved, consider

changing to a setting of 0 or 1 to find the optimal balance for your work

environment.

Regardless of the LAYOUTREGENCTL setting, if you redefine a block or undo

a layout switch, the drawing is regenerated the first time you switch to any

layout that contains saved viewports.

See also:

Work on a Named Layout

LEGACYCTRLPICK

Specifies the keys for selection cycling and the behavior for Ctrl-click.

IntegerType:

RegistrySaved in:

2Initial value:

Ctrl-click is used to select subobjects (faces, edges, and vertices) on

3D solids, surfaces, and meshes.

Ctrl-click is used to cycle through overlapping objects. Disallows

using Ctrl-click to select subobjects on 3D solids, surfaces, and

meshes.

Ctrl-click is used to select subobjects (faces, edges, and vertices) on

3D solids, surfaces, and meshes when SUBOBJSELECTIONMODE

(page 1449) is set to 0.If SUBOBJSELECTIONMODE is set to 1, 2, 3, or

4, it is not necessary to hold down the Ctrl key to select subobjects.If

you hold down the Ctrl key when SUBOBJSELECTIONMODE is set

to 1, 2, 3, or 4, the subobject filter is turned off until the Ctrl key is

released.