2012

ISAVEPERCENT
Determines the amount of wasted space tolerated in a drawing file.
IntegerType:
RegistrySaved in:
50Initial value:
The value of ISAVEPERCENT is an integer between 0 and 100. The default
value of 50 means that the estimate of wasted space within the file does not
exceed 50 percent of the total file size. Wasted space is eliminated by periodic
full saves. When the estimate exceeds 50 percent, the next save will be a full
save. This resets the wasted space estimate to 0. If ISAVEPERCENT is set to 0,
every save is a full save.
See also:
Set Up the Drawing Area
ISOLINES
Specifies the number of contour lines displayed on the curved surfaces of 3D
solids.
IntegerType:
DrawingSaved in:
4Initial value:
Valid settings range from 0 to 2047.
See also:
Create Solids
L System Variables
LARGEOBJECTSUPPORT
Controls large object size limit support when you open and save drawings.
IntegerType:
System Variables | 1343